Amark AM-333 Vehicle Auto-Gate Interface Module

Amark AM-333 Vehicle Auto-Gate Interface Module

The AM-333 is designed to save you time and hassle of fumbling for your auto-gate remote control as you drive into your porch.

The installation of the AM-333 is straightforward without complex wiring. You can choose either to link the remote to the high-beam light switch or opt for a dedicated push button switch to open or close your auto-gate from the comfort of your vehicle.

It works without the need of additional battery as it is connected directly to your car's 12V power supply.

AM-333 works with most of the auto-gate remote control frequencies available on the market.

It looks really cool when you activate your auto-gate while having a passenger who had no idea you have the AM-333 installed.

How to Pair Your Auto Gate Remote Control with the AM-333 Auto Gate Interface Module

Option A: If Your Auto Gate Remote Control is one of these frequencies: 315Mhz, 330Mhz or 433Mhz
1. Connect DC 12V power supply to the AM-333.
2. When the LED turns Red, connect Blue wire to reset the AM-333. LED will turn to Green. After 1-5 seconds, LED will turn Red for 1 second and then back to Green.
3. Release the Blue wire. The AM-333 is now ready to pair with a new auto gate remote control.
4. Hold your original auto-gate remote control near to AM-333 LED area. The LED will turn from Green to Red and the pairing between the AM-333 and your remote control is complete.

Option B: If Your Auto Gate Remote Control is not 315Mhz, 330Mhz or 433Mhz
1. Connect DC 12V power supply to the AM-333.
2. When the LED turns Green, the AM-333 is ready to pair with a new auto-gate remote control.
3. Hold your original auto-gate remote control near to AM-333 LED area. The LED will turn from Green to Red and the pairing between the AM-333 and your remote control is complete.

Wiring Diagram

The diagram below shows the wiring diagram of the AM-333.


Here are 4 recommended installation wiring diagrams for AM-333:

1) Activate remote via Hi-Beam Light Switch (Positive)



2) Activate remote via a Push Button Switch

3) Activate remote via High Beam Light Switch with existing HID Ballast installed

4) Activate via High Beam Light Switch for most vehicles (Negative)

Write a review

Note: HTML is not translated!
    Bad           Good

12 Product(s) Sold
  • RM180.00
  • Ex Tax: RM180.00